This instructable will clearly describe unlike the Comcast manual how to program your remote to operate a TV, DVD, Stereo, or other device. Before we begin, make sure your remote has a good set of batteries by using it to turn your cable box off and on. Find the 5 digit codes that correspond with the brand of your TV, DVD, or other device in the list below.
You may want to write them on a scrap of paper. Read the following steps before performing them. Press the cable button at the top of the remote. This will clear any button pushes from memory. If you mess up on any of the following steps, press the exit button followed by the cable button and start back at step 3.
Enter the first 5 digit code you wrote down into the keypad. If it does not, Go back to 2 above on this page. Now, test your remote by pressing the TV or AUX button whichever one you programmed , and aiming it at your device. Then press the power button. If your device turns on and off as you press power on the remote, then you have successfully completed programming and should skip to step 5.
If the remote does not operate the device, go back to 2 above on this page. OR of you have tried all the codes or you want to do this faster go to the next step. Be sure to press the cable button to clear the remote. If you mess up any steps, press the exit button followed by the cable button and go back to 2.
Turn on your TV or other device by pressing its power button. Type into the keypad, NOT Press the power button and then aim the remote at your device. Press the channel up button until the device turns off. Stop pressing immediately when the device turns off. Press the setup button to lock in the IR code. Check that you did this correctly by turning your device on and off with the remote.
If it works, continue. If it does not, go back to 2. To find codes not listed, press A and D, and ch up until the tv turns off You can also pick an XR11 remote anytime at your local service center. I also dont have Voice Command working so this XR15 is a bust for me so far. I went about 25 times and no change. Now have to deal with 2 remotes to watch tv. Odd for a Sharp but it happens. The DVR has nothing to do with setting up your codes.
This worked!!! Thank you so much, i've been looking everywhere for that code. That worked. Great and thanks. Code worked. Thank you! Press and hold Setup until the light at the top of the remote changes from red to green. Enter The light should flash green twice.
Once the TV turns off, press Setup to lock in the code. Press the TV power button on the remote. If the TV turns on, you're all set!
Press and hold the xfinity and Mute buttons together for five seconds until the light at the top changes from red to green. Type the first five-digit code for the TV manufacturer. If the remote light blinks green twice, the code is correct. If the remote light blinks red then green, the code is incorrect. Aim the remote at the TV, and press the Power button.
0コメント